Displaying The Daylight Savings Time Settings; Configuring A Static Route Using Acli; Variable Definitions; September 2016 Quick Start Configuration - Avaya 3500 Quick Start Configuration

Connecting to the switch

Displaying the daylight savings time settings

Display the daylight savings time settings.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
show clock summer-time
Example
The following figure provides a sample of the output of the show clock summer-time
command.
switch(config)#show clock summer-time
Summer time recurring is set to:
start: on Tuesday in the 1st week of June at 12:01
end: on Saturday in the 3rd week of September at 23:59
Offset: 60 minutes.
Daylight saving time is disabled

Configuring a static route using ACLI

Create static routes to manually configure a path to destination IP address prefixes.
Before you begin
• Enable IP routing globally.
• Enable IP routing and configure an IP address on the VLANs to be routed.
Procedure
1. Log on to ACLI in Global Configuration command mode.
2. At the command prompt, enter the following command:
[no] ip route <dest-ip> <mask> <next-hop> [<cost>] [disable]
[enable] [weight <cost>]

Variable definitions

The following table describes the parameters for the ip route command.
September 2016 Quick Start Configuration
Comments on this document? infodev@avaya.com
32