Custom Network Interface Settings
Specifying Dial Settings
Use Dial... to specify dial parameters for SLIP interfaces.
Procedure
1. Choose Settings... from the Network menu. The
Custom window appears, as shown in Figure 5-1.
2. Choose Setup from the Custom window menu bar.
3. Choose Dial... from the Setup menu. The Dial Settings
dialog box appears, as shown in Figure 5-7.
Table 5-5 describes the fields on the Dial Settings
dialog box.
Figure 5-7. Dial Settings Dialog Box
4. Enter the appropriate dial settings.
NOTE:
Leave the Dial field blank to indicate Answer mode when
connected.
5. Choose OK.
Issue 2 December 1996
5-11