Setting The Number Of Subnet Mask Bits; Subnet Mask Dialog Box - Paradyne COMSPHERE 6700 SERIES Network Configuration Manual

Custom Network Interface Settings
Setting the Number of Subnet
Mask Bits
Use Subnet Mask... to specify the number of subnet mask bits.
These bits are used to partition IP addresses into a network and
host portion, if needed.
Procedure
1. Choose Settings... from the Network menu. The
Custom window appears, as shown in Figure 5-1.
2. Choose Setup from the Custom window menu bar.
3. Choose Subnet Mask... from the Setup menu. The
Subnet Mask dialog box appears, as shown in
Figure 5-4.
Figure 5-4. Subnet Mask Dialog Box
4. Click and drag the Subnet Mask slide bar to the correct
location, or type the number of subnet mask bits.
5. Choose OK.
5-6
Issue 2 December 1996