Siemens SINAMICS S120 Manual page 461

Attaching the hood
The numbers in parentheses in the installation steps refer to the diagram below.
1. Options M43 and M54 only:
2. Fit the hood to the roof of the cabinet at the positions specified (fixing points for the crane
3. Attach original M12 roof screws
4. M6 screw and washers (order: Attach the screw, spring-lock element, small washer, large
5. If the hood is very wide, use additional screws
Note
If cabinet units are installed in a side-by-side configuration, the hoods must be flush-mounted
in a line across the cabinet units.
Figure 8-48
Cabinet Modules
Manual, (GH5), 05/2010, A5E03263538A
Secure the contact surfaces of the hood on top of the cabinet using the sealing tape
provided.
transport assembly).
②
washer) from below.
Mounted hood
8.38 M23/M43/M54, degree of protection IP23/IP43/IP54
①
from above.
③
.
Options
461