Chassis; Headlamp - Suzuki GS-1000 Service Manual

CHA SSIS
IGNITION SWITCH
REMOVAL
Remove the headlamp and then each lead
wire connected within the headlamp housing.
Remove the two headlamp "housing bolts and
remove the housing.
Remove
two
screws with 5 m m Allen wrench
and remove the ignition switch.
Fig. 10-15.
MOUNTING
a
Mount parts i n the reverse
order to removal.
e
Route the lead wires of ignition switch, left
handle bar switch, front brake switch and
turn signal lamp through the
lower
hole in the
headlamp housing and fasten the headlamp
housing with
two
bolts.
Connect each lead wire.
Connect the lead wire of the ignition switch
to
the coupler
a
on the wire harness side.
Connect the lead
wire
of the
right
handle bar
switch to the
coupler
@
on
the wire harness
side.
The orange
and white lead wires of the
front
brake switch are to be connected respectively
with
the
orange and
white
ones on the wire
harness side.
The black/white lead wires of the left and
right ground wire for the front turn signal are
-
to
be connected
respectively
with the
black/white
ones
on the wire harness side.
Also connect the black lead
wire
of the left
---
turn signal body
to
the black
one
on the wire
harness, and
connect the
right
side lead wire
to
the light green
one on the
wire harness
side.
a
Connection
of
headlamp. Connect the con-
nection coupler
'3
for
the
headlamp to
the
headlamp connection.
Fig.
10-16.
Secure the headlamp with three
screws.
Adjust
the vertical beam angle of the
headlamp (see page 10-5).