Throttle Cable - Suzuki GS-1000 Service Manual

CHA
SSIS
MOUNTING
Route the clutch cable between carburetors
No. I and 2. Next,
as
show
in
the
drawing
below, route
it dong
the u p p ~ left portion
of
the ignition mil below
the upper steering
bracket
to
the left side of the ignition switch
through the tacho-speedometer mounting
brackets.
0
Mount the clutch cable
on the
clutch lever.
m
Mount
adjuster bolts on the clutch cover side
and fasten the cam lever with
cam
lever bolts.
m
Adjust
the clutch lever play (see page 3- 13).
THROTTLE CABLE
REMOVAL
Remove the fuel tank.
e
Loosen lock nuts for
both cables on the throt-
tle
grip portion and firmly tighten both cable
adjusting nuts to provide suf'Ecient cable
play.
m
Remove cable adjusters
from the bracket
at
the opening and
closing ports on the car-
buretor
side
to remove the inner cable from
lever.
m
A clamp
fixing
the throttle wire is located
in
front of the ignition coil. Draw
out the
throt-
tle wire over the bent clamp.
Remove tbe right handlebar switch screws to
separate
the upper and
lower portions of the
handle switch.
a
Screw back the cable adjusting nut
@
at rhe
closing side to remove it from the throttle
cable guide, and loosen the cable guide lock
nut to remove cable guide
@
from the handle
bar switch.
a
Remove throttle inner cable
3
at the closing
side from the throttle grip and remove the
cable.
Loosen
the
cable
guide lock nut at the open-
ing
side and remove the cable guide
from the
handlebar switch.
a
Remove
throttle inner cable
@at
the opening
side
from
the throttle grip and remove
the
calbe.