Speedometer Cable; Tachometer Cable - Suzuki GS-1000 Service Manual

CHA S SJS
Fig. 10-8.
MOUNTING
Mount the throttle
cable
guide
at
the
open-
ing
side and the throttle cable guide
@
at the
closing side on the handle bar switch and
lightly tighten the lock nuts.
Fig. 10-9.
m
Mount
the
throttle Inner cables
at the opening
and closing sides respectively on the front
and rear holes in the throttle grip.
m
F i x the right handlebar switch
on
the
handlebar.
Route tmth cables through the space between
the
tachometer
and
ignition switch and then
&ween the steering head
pipe
and the right
front fork.
F i x
the throttle wire with the clamp on
the
f m t of
the
ignition coil.
Mount
the
inner cable at the
opening side on
the
lever at the rear side. Mount cabIe ad-
juster on the bracket and fix
i t
with the upper
and lower
nuts.
-.
Mount the inner cable at the closing side
on
the lever at the front side and mount the cable
adjuster on the bracket to fix it with
the
upper
and lower nuts.
If it is dimcult to mount the inner cable
on
the
lever,
turn the
throttle grip to the full open
position and then mount the
inner cable.
Adjust the throttle cable
(see
page 3- 13).
Mount the fueI tank.
SPEEDOMETER CABLE
REMOVAL -
Remove both ends af the speedometer cable
with pliers and remove
the
cable from the
speedometer pear housing and speedometer
from the front hub.
MOUNTING
Route
the speedometer cable
to
the
brake oil
hose joint portion and through the cable
guide. Mount the cable nut ofthe upper end
on
the
speedometer and tighten it with pliers.
a
Mount
the
lower end of the cable on
the
speedometer gear housing. Then rotate the
wheel
so
that the groove at
the
end of t h e in-
ner cable meshes with the projection of h e
. .
speedometer pinion and tighten the cable nut.
-,
TACHOMETER CABLE
REMOVAL
a
Remove
the tachometer
cable
from the
tachometer side
and the cylinder head side
with pliers.
.-
M OU
NTlNG
Route the
tachometer
cable from the rear
portion
of the speedometer between the steer-
ing head pipe
and right front fork and mount
it
on
the cylinder head covet.
At this time make sure that the
inner cable
engages with the tachometer gear, and
tighten
the cable
nut.