Replacing The Oven Light - Thermador X302X Care & Use Manual

CAUTION: If the light cover is damaged or
broken, do not use the oven until a new cover is in
place.
ATTENTION: Si la couverture d'éclairage est
endommagée, ou cassée, ne pas utiliser le four
jusqu' à une nouvelle couverture est en place.
WARNINGS:
To prevent electrical shock and or personal injury:
• Before replacing the light bulb, be sure the
electric power is turned off at the circuit
breaker.
• Do not operate the oven unless the light cover
is securely in position.
• Halogen bulbs get HOT instantly when turned
ON.
• Be sure the oven and light bulb are cool.
AVERTISSEMENTS:
Pour empêcher le choc électrique et/ou la blessure
personnelle:
• Avant de remplacer l'ampoule, soyez
cer tain l'interrupteur
automatique sur le cadre du four est
déprimé.
• Ne pas faire fonctionner le four sauf si la
couverture d'éclairage est solidement dans sa
place.
• L'ampoule d'Halogène ALLUMÉE de vient
CHAUDE immediatement.
• Soyez certain que le four et l'ampoule sont frais.
Do-It-Yourself Maintenance
d'éclairage

Replacing the Oven Light

The oven lights have a removable lens cover and a halo-
gen light bulb. The ceramic light socket housing is not
removable by the user.
Instructions for Replacing Light Bulb
Replacement Halogen lamp: 12 Volt, 10 Watt. Order from
Thermador Part Number 14-38-551. See Page 36, How
to Obtain Service.
1. Observe ALL WARNINGS on this page before
beginning this replacement.
2. Remove oven
racks.
3. Slide the blade
of a table knife
between oven
wall and the
center of the
side of the
p r o t e c t i v e
glass lens
cover.
4. Support the
glass lens cover with two fingers along the bottom
edge to prevent the cover from falling to the bottom
of the oven.
5. Gently twist the knife blade to loosen the glass lens
cover.
6. Remove the glass lens cover.
7. Remove the bulb by grasping and sliding the bulb
straight up until the two prongs have cleared the
ceramic holder.
8. Do not touch the glass of the new replacement bulb
with your fingers. It will cause the bulb to fail when
it first lights. Grasp the replacement bulb with a
clean paper towel or facial tissue with the prongs
facing down. Locate the two prongs in the ceramic
holder, gently poking until the two prongs locate in
the ceramic socket.
9. Press down to seat the bulb.
10. Snap the protective glass lens cover over the bulb
housing.
11. Turn on circuit breaker.
Page 33
Lens Cover
Light Bulb
Light Socket