Mounting Rails & Accu-Fence; Optional Wood Extension Table; Installing Dust Shroud; Installing Switch - Powermatic 64A Instruction Manual

MOUNTING RAILS & ACCU-FENCE
With the extension wings properly aligned, the rail and
fence assembly can now be mounted to the saw.
Consult the separate Accu-Fence manual for instruc-
tions.

OPTIONAL WOOD EXTENSION TABLE

For instructions on mounting the accessory wood ex-
tension table, or router table, consult your Accu-Fence
manual.

INSTALLING DUST SHROUD

Tools Required
Small adjustable wrench
phillips screwdriver.
TIP: Since the dust shroud is installed from beneath,
aid from a helper to install the screws and tabs will
make this task much easier.
1. From under the saw, position the dust shroud at
an angle to go through the opening between the stand
and the saw. Set the lip of the shroud to sit on the top
side of the stand as shown in Figure 19.
2. Attach two 3/16-24 x 5/8 pan head screws and
two 3/16 star washers to the tabs, and reaching in
from the motor side of the saw, push the screws
through the holes provided in the stand.
3. Attach two 3/16 nuts from the bottom side, and
with both tabs positioned over the lip of the shroud,
tighten down both screws.

INSTALLING SWITCH

NOTE: The switch can not be mounted until the fence
and rails are mounted. Attach the switch under the
first screw from the left on the front rail. See Figure
20. The switch mounting bracket has a slot for ad-
justment.
The table saw is equipped with a push-button switch
with safety device, shown in Figure 20. When the
safety key is inserted into the start button, the button
cannot be pushed in, thus preventing accidental start-
ing of the saw. It is recommended that the safety key
be placed on the machine whenever the machine is
not in use.
FIGURE 19
FIGURE 20
15