Using the setup wizard
Use the procedures in this section to connect to the web-based manager and the setup wizard to create the
initial configuration of your DFL-500.
Connecting to the web-based manager
You require:
·
A computer with an ethernet connection
·
Internet Explorer version 4.0 or higher
·
A crossover cable or an ethernet hub and two ethernet cables
To connect to the web-based manager:
·
Set the IP address of the computer with an ethernet connection to the static IP address 192.168.1.2 and a
netmask of 255.255.255.0.
·
Using the crossover cable or the ethernet hub and cables, connect the Internal interface of the DFL-500
to the computer ethernet connection.
·
Start Internet Explorer and browse to the address https://192.168.1.99 .
·
The DFL-500 login page appears.
·
Type admin in the Name field and select Login.
DFL-500 login page
Starting the firewall setup wizard
To start the firewall setup wizard:
·
Select the Wizard button at the upper right of the web-based manager.
·
Use the information that you gathered in
next button to step through the wizard pages.
·
Confirm your configuration settings and then Select Finish and Close.
DFL-500 User Manual
NAT/Route mode settings
to fill in the wizard fields. Select the
20