Adding An Ipsec Vpn Policy - D-Link DFL-500 User Manual

end of the VPN tunnel.
Netmask
Complete the following procedures on both VPN gateways to add the source and destination addresses.
Adding a source address
To add the source address to the internal address list:
·
Go to Firewall > Address > Internal .
·
Select New to add a new address.
·
Enter the Address Name and the IP Address and NetMask of the network that can connect to the near
end of the VPN.
Example internal source address for VPN gateway 1
·
Select OK to save the source address.
Adding a destination address
To add the destination address to the external address list:
·
Go to Firewall > Address > External .
· Select New to add a new external address.
·
Enter the Address Name and the IP Address and NetMask of the network behind the other VPN gateway
at the far end of the VPN tunnel.
·
Select OK to save the external address.

Adding an IPSec VPN policy

Add a VPN policy to associate the source and destination addresses with the VPN tunnel.
Example IPSec Autokey VPN policy configuration
VPN between two internal
Example IPSec Autokey VPN policy configuration
Description
Source
The source address that you added for the VPN
Address
(See IPSec Autokey VPN
Destination
The destination address that you added for the
Address
VPN (See IPSec Autokey VPN
The name of the VPN tunnel that you created for
VPN Tunnel
the VPN
DFL-500 User Manual
networks.
addresses).
addresses).
(See Example IPSec Autokey VPN
shows the VPN policy configuration for the VPN in
Main office (VPN
gateway 1)
Main_Office
Branch_Office
Branch_Office_VPN
255.255.255.0 255.255.255.0
Branch office (VPN
gateway 2)
Branch_Office
Main_Office
Branch_Office_VPN
Example
58