DFL-1000 login page
Starting the Quick Setup Wizard
To start the Quick Setup Wizard:
•
Click the Wizard button at the upper right of the web-based manager.
•
Select the operating mode: Network Address Translation (NAT) or Transparent.
If you selected Network Address Translation (NAT), use the information that you gathered in
mode configuration information
wizard pages.
If you selected Transparent, use the information that you gathered in
information
to fill in the wizard fields. Click the next button to step through the wizard pages.
•
Confirm your configuration settings and then click Finish and Close.
You have now completed the initial configuration of the DFL-1000, and you can proceed to connect
the DFL-1000 to your network using the information in
Reconnecting to the web-based manager
After running the Quick Setup Wizard, if you changed the IP address of the internal interface or switched
to Transparent Mode, you must re-connect to the web-based manager using a new IP address:
•
In NAT mode if you changed the IP address of the internal interface, browse to https:// followed by the
new IP address of the internal interface
•
In Transparent mode, connect to the DMZ interface and browse to https:// followed by the
Transparent mode Management IP address
Otherwise you can reconnect to the web-based manager by browsing to https://192.168.1.99.
Configuring the DFL-1000 from the CLI
To connect to the DFL-1000 CLI you require:
•
A computer with an available communications port
•
A null modem cable with a 9-pin connector to connect to the communications port on the back panel
of the DFL-1000
•
Terminal emulation software such as HyperTerminal for Windows
DFL-1000 User's Manual
to fill in the wizard fields. Click the next button to step through the
Connecting the DFL-1000 to your
NAT
Transparent mode configuration
network.
19