Advanced Configuration Options; Power-On State - Agilent Technologies 34410A User Manual

Advanced Configuration Options

Power-On State

At power–on, the multimeter displays all segments of the two–line display
and all annunciators, for a period of several seconds, then changes to the
default display mode. The following tables show the state of multimeter
parameters at power on. Parameters marked with a bullet ( ) are stored
in non–volatile memory, and are not affected by power–on or a system
reset. For those parameters, the initial factory settings are shown. All
other parameters are stored in volatile memory, and are reset to the
indicated values at power–on, after a front–panel Reset command, or after
a *RST or SYSTem:PRESet command is issued from the remote interface.
34410A/11A User's Guide
Measurement Configuration
Function
Range
Resolution
Integration Time
Autozero
Aperture
Input Impedance
AC Input Filter (bandwidth)
Nulls (for individual measurement functions)
Second Display
Math Operations
Math State
Math Registers
dB relative value
dBm reference resistance
Triggering Operations
Trigger Count
Trigger Source
Trigger Delay
Sample Count
Sample Source
Sample Timer
Features and Functions
Factory Setting
DC Volts
Autorange (for all functions)
6.5 digits (0.3 ppm x Range)
*
NPLC on, 1 PLC
*
On
*
Off, 1 second
10 MW (fixed for all VDC ranges)
20 Hz (medium filter)
Off, 0 for all measurement functions
Off
*
for all dc measurements
Factory Setting
Off
Cleared (all registers)
0
600W
Factory Setting
1
Immediate
Auto Delay
1
Auto
1 second
2
*
*
49