Table of Contents
Advertisement
5
Press – or + repeatedly until "ONCE?",
"DAILY?" or "WEEKLY?" appears.
If you select "ONCE?", the recording timer
activates only once. If you select "DAILY?",
the timer activates at the same time every
day. If you select "WEEKLY?", the timer
activates at the same time on the set day of
every week.
6
Press ENTER/YES.
If you select "ONCE?" or "WEEKLY?", the
day indication starts flashing. If you select
"DAILY?", the hour indication starts
flashing.
7
Press – or + repeatedly to select the
desired day.
If you select "DAILY?" in step 5, proceed to
step 9.
8
Press ENTER/YES.
The hour indication flashes.
Noon is indicated as 12:00 PM, and midnight
as 12:00 AM.
9
Set the time to start recording.
Press – or + repeatedly to set the hour, then
press ENTER/YES.
The minute indication flashes.
Press – or + repeatedly to set the minute,
then press ENTER/YES.
The hour indication flashes again.
10
Set the time to stop recording following
the procedure in step 9.
11
Select the recording mode (e.g., LP2)
by pressing – or +, then press ENTER/
YES.
The timer recording settings appear, then the
original display returns.
12
Insert a recordable MD.
If you use a partially recorded MD, recording
starts after the recorded tracks.
13
Press ?/1 to turn off the system.
To change the setting
Start over from step 1.
To activate/cancel the timer
1 Press CLOCK/TIMER SELECT, then press –
or + repeatedly until "REC SELECT?" appears
and press ENTER/YES.
2 Press T or t repeatedly to select the timer
number (REC 1 to 3), then press – or +
repeatedly to select the timer number (set) or
"–" (cancel) and press ENTER/YES. If you
have not set the recording timer, " . " appears
instead of the timer number or "–".
continued
59
Advertisement
Table of Contents
