Table of Contents
Advertisement
2
Press TUNER/BAND repeatedly to
select "FM" or "AM".
3
Press TUNING MODE repeatedly until
"PRESET" appears.
4
Turn –l/L+ to select the desired
preset station.
Station name*
Preset number
* The station name appears only if you have
labelled the station (see page 55).
You can also select the preset numbers with
the number buttons on the remote.
5
Press REC/REC IT.
The MD deck stands by for recording.
6
Press MD HS.
Recording starts.
To stop recording
Press s .
Tips
• If noise is heard while recording an AM radio
programme, move the AM loop aerial to reduce the
noise or connect a ground wire to the U terminal
(see page 62).
• You can switch the recording mode before step 5
and record for long times. For details, see
"Recording for long times" (page 32).
• You can adjust the recording level to the desired
volume after performing step 5 (see page 51).
Frequency
Before pulling out the mains lead
MD recording is completed when the MD Table
of Contents (TOC) is updated. The TOC is
updated when you eject the MD or press ?/1 to
turn off the system. Do not pull out the mains lead
before updating the TOC (while "TOC" is lit) or
while updating the TOC (while "TOC" is flashing)
to ensure a complete recording.
Note
If the MD is record protected, "C11" and "Protected"
appear alternately and the MD cannot be recorded.
Remove the MD, then slide the record protection tab
to the closed position (see page 26).
15
Advertisement
Table of Contents
