How To Assemble; How To Operate - Royal Vacuum Cleaner Owner's Manual

HOW TO ASSEMBLE

NOTE: To ensure proper operation of the cleaner, verify that the rubber O-ring is in place and tighten all collars.
1. 1a.
To attach the lower handle, align with nozzle
opening in the base of the cleaner
(Diagram 1). Push together firmly and turn
the knob clockwise to tighten (Diagram 1a).
3.
3a.
To attach the upper handle, align with
middle section of cleaner and push firmly
into place (Diagram 3). Turn the knob
clockwise to tighten (Diagram 3a).

HOW TO OPERATE

WARNING: FULLY ASSEMBLE BEFORE OPERATING.
1. 2.
Plug the extension cord firmly
To prevent the cords from coming
into the pigtail cord making sure
apart while vacuuming, create a
that both ends are completely
loophole with the extension cord and
engaged. NOTE: Use only a 17
slide through opening at top of cord
gauge or higher 3-wire SJT
lock (Diagram 2). Allow loophole to
extension cord with this cleaner.
slip over hook at bottom of cord lock
Using a cord of different type or
then remove excess slack by pulling
AWG may result in increased
the long end of the extension cord
risk of fire or electric shock.
(Diagram 2a).
2. 2a.
To attach the bag, hold the handle and firmly
push into lower handle (Diagram 2). Turn the
top knob counterclockwise to tighten and
snap bag clip onto lower handle (Diagram 2a).
4.
To keep the cord out of the
way while vacuuming, snap
it into the cord clip on the
back of the upper handle.
2a. 3.
FRONT
Plug extension cord into
electrical outlet.
power switch to the "ON"
position.
6
Turn