Plugging In This Unit - Yamaha DSP-A2 Owner's Manual

PREPARATION

Plugging in this unit

• After completing all connections, plug the AC power cord
into an AC outlet.
(*2)
(*1):
AC OUTLET(S)
(Europe, China and General models)
.......................................................... 3 SWITCHED OUTLETS
(U.K. model) ........................................ 1 SWITCHED OUTLET
Use these to connect the power cords of your components to
this unit.
The power to the SWITCHED outlets is controlled by this unit's
STANDBY/ON switch or the remote controller's SYSTEM
POWER ON and STANDBY keys. These outlets will supply
power to any connected unit whenever this unit is turned on.
The maximum power (total power consumption of components)
that can be connected to the SWITCHED AC OUTLET(S) is
100W.
24
VOLTAGE SELECTOR
SPEAKERS
REAR
( SURROUND )
TION MANUAL FOR CORRECT SETTING.
IMPEDANCE SELECTOR
MAIN
A
B
(General model)
• Unplug the AC power cord from the AC outlet if this unit is
not to be used for a long period of time.
AC OUTLETS
SWITCHED
SET BEFORE POWER ON
CENTER : 4ΩMIN. / SPEAKER
FRONT : 6ΩMIN. / SPEAKER
REAR : 6ΩMIN. / SPEAKER
MAIN A OR B: 4ΩMIN. / SPEAKER
A B : 8ΩMIN. / SPEAKER
CENTER : 8ΩMIN. / SPEAKER
FRONT : 8ΩMIN. / SPEAKER
REAR : 8ΩMIN. / SPEAKER
MAIN A OR B: 8ΩMIN. / SPEAKER
A B : I 6ΩMIN. / SPEAKER
(*2):
Voltage Selector (China and General models
only)
The voltage selector on the rear panel of this unit must be
set for your local main voltage BEFORE plugging into the
AC main supply.
Voltages are 110/120/220/240 V AC, 50/60 Hz.
To AC outlet
I00W
MAX.
TOTAL
(*1)