Connections; Audio/Video Source Equipment - Yamaha DSP-A2 Owner's Manual

PREPARATION

Connections

Caution: Plug in this unit and other components after all connections are completed.
All connections must be correct, that is to say L (left) to L, R (right) to R, "+" to "+" and "–" to "–". Also refer to the owner's manual for
each of your components.

Audio/video source equipment

Use RCA type pin plug cables for audio/video units with the exception described later.
The output (or input) terminals of YAMAHA audio/video units numbered as 1, 2, 3, 4, etc. on the rear panel must be
connected to the same-numbered terminals of this unit.
Basic connections of audio units
CD player
MD recorder,
Tape deck, etc.
Tuner
GND terminal (For turntable use)
(*1):
Connecting the ground wire of the turntable to the GND
terminal will normally minimize hum, but in some cases
better results may be obtained with the ground wire
disconnected.
14
(*1)
OUTPUT
DIGITAL
RF SIGNAL
DVD/LD
CD
COAXIAL
OPTICAL
LINE OUT CD
LINE IN
IN
(PLAY)
TAPE/MD
OUT
(REC)
OUTPUT
DVD/LD
TV/DBS
DIGITAL SIGNAL
Turntable
GND AUDIO SIGNAL AUDIO SIGNAL
PHONO
1
CD
3
IN
( PLAY )
TAPE/MD
4
OUT
( REC )
MAIN
SURROUND
SUB WOOFER CENTER
EXTERNAL DECODER INPUT
: Indicates the direction of signals.
(Europe model)
VIDEO SIGNAL
VIDEO
S VIDEO
DVD/LD DVD/LD
TV/DBS
TV/DBS
IN IN
VCR 1 VCR 1
OUT OUT
IN IN
VCR 2 VCR 2
OUT OUT
2
TUNER
S VIDEO
MONITOR
OUT
VIDEO