Yamaha DSP-A2 Owner's Manual page 18

PREPARATION
For connecting with a TV monitor that uses a 21 pin
connector for input (Europe and U.K. models only)
Make a connection as figured below with a commercially
available scart-plug connector cable.
MAIN
IN
(PLAY)
SURROUND
TAPE/MD
OUT
(REC)
DVD/LD
SUB WOOFER
EXTERNAL DECODER INPUT
TV/DBS
DIGITAL SIGNAL
TV monitor
16
(Europe model)
IN IN
VCR 2 VCR 2
OUT OUT
2
TUNER
CENTER
S VIDEO
MONITOR
OUT
VIDEO
No connection
Scart-plug connector
cable
PAL/NTSC switch (China and General models only)
This unit is designed for use with the NTSC and PAL television
formats. Set this switch to the position for the format your TV
monitor employs.
COUPLER
MAIN
PRE MAIN
OUT IN
PAL: Set to this position if your TV monitor employs the
PAL format.
* Outputs signals in the PAL format no matter which
NTSC: Set to this position if your TV monitor employs the
NTSC format.
* Outputs signals in the NTSC format no matter which
Note
Be sure to input a video signal which employs the same format
that your TV monitor employs, otherwise a picture will not be
played back normally.
IN
VCR 1
OUT
PAL NTSC
IN
VCR 2
PAL/NTSC switch
format (PAL or NTSC) of video signal is sent from
an external video unit to this unit.
format (PAL or NTSC) of video signal is sent from
an external video unit to this unit.
CAUTION