Handling Of Radar Sensors - Subaru WRX Owner's Manual

must accept any interference, including
interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux
CNR d Industrie Canada applicables aux
appareils radio exempts de licence. L ex-
ploitation est autorisée aux deux condi-
tions suivantes: (1) l appareil ne doit pas
produire de brouillage, et (2) l utilisateur
de l appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage
est susceptible d en compromettre le
fonctionnement.

Handling of radar sensors

Radar sensors
The radar sensors, one on each side of
the vehicle, are mounted inside the rear
bumper.
Starting and operating/BSD/RCTA
NOTE
. To ensure correct operation of the
BSD/RCTA, observe the following pre-
cautions.
Always keep the bumper surface
near the radar sensors clean.
Do not affix any stickers or other
items on the bumper surface near
the radar sensors.
Do not modify the bumper near
the radar sensors.
Do not paint the bumper near the
radar sensors.
Do not expose the bumper near
the radar sensors to strong im-
pacts. If a sensor becomes misa-
ligned, a system malfunction may
occur, including the inability to
detect vehicles entering the detec-
tion areas. If any strong shock is
applied to the bumper, be sure to
contact your SUBARU dealer for
inspection.
Do not disassemble the radar
sensors.
. If the radar sensors require repair or
replacement, or the bumper area
around the radar sensors requires
repair, paintwork or replacement, con-
tact your SUBARU dealer for assis-
tance.
7-63