Handling Of Radar Sensors - Subaru impreza 2017 Owner's Manual

7-56
Starting and operating/BSD/RCTA
. Canada-spec. models
NOTE
This device complies with Industry
Canada s licence-exempt RSSs. Opera-
tion is subject to the following two
conditions: (1) This device may not
cause interference; and (2) This device
must accept any interference, includ-
ing interference that may cause unde-
sired operation of the device.
REMARQUE
Le présent appareil est conforme aux
CNR d Industrie Canada applicables
aux appareils radio exempts de licence.
L exploitation est autorisée aux deux
conditions suivantes: (1) l appareil ne
doit pas produire de brouillage; (2)
l utilisateur de l appareil doit accepter
tout brouillage radioélectrique subi,
même si le brouillage est susceptible
d en compromettre le fonctionnement.

Handling of radar sensors

1) Radar sensors (sedan)
1) Radar sensors (5-door models)
The radar sensors, one on each side of
the vehicle, are mounted inside the rear
bumper.
To ensure correct operation of the BSD/
RCTA, observe the following precautions.
. Always keep the bumper surface near
the radar sensors clean.
. Do not affix any stickers or other items
on the bumper surface near the radar
sensors.
. Do not modify the bumper near the
radar sensors.
. Do not paint the bumper near the radar
sensors.
. Do not expose the bumper near the
radar sensors to strong impacts. If a
sensor becomes misaligned, a system
malfunction may occur, including the
inability to detect vehicles entering the
detection areas. If any strong shock is
applied to the bumper, be sure to contact
your SUBARU dealer for inspection.
. Do not disassemble the radar sensors.
NOTE
If the radar sensors require repair or
replacement, or the bumper area
around the radar sensors requires
repair, paintwork or replacement, con-
tact your SUBARU dealer for assis-
tance.