Certification For The Bsd/Rcta; Handling Of Radar Sensors - Subaru Forester 2017 Owner's Manual

vehicle
When using a chassis dynam-
ometer or free roller device, etc.
When running the engine and
making the wheels rotate while
lifting up the vehicle
. If the ignition switch is turned to the
LOCK / OFF position, the last known
status of the system is maintained. For
example, if the ignition switch is turned
to the LOCK / OFF position with the
BSD/RCTA deactivated, the BSD/RCTA
will remain deactivated the next time
the ignition switch is turned to the
ON position.
. If the vehicle battery is disconnected
due to situations such as battery
terminal or fuse replacement, after the
battery is reconnected, the BSD/RCTA
will be activated.
Certification for the BSD/
RCTA
. U.S.-spec. models
FCC ID: OAYSRR2A
CAUTION
FCC WARNING
Changes or modifications not ex-
pressly approved by the party re-
sponsible for compliance could void
the user s authority to operate the
equipment.
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence received, including interference that
may cause undesired operation.
. Canada-spec. models
This device complies with Industry
Canada licence-exempt RSS standard
(s). Operation is subject to the following
two conditions: (1) this device may not
cause interference, and (2) this device
must accept any interference, including
interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux
CNR d Industrie Canada applicables aux
appareils radio exempts de licence. L ex-
ploitation est autorisée aux deux condi-
tions suivantes: (1) l appareil ne doit pas
produire de brouillage, et (2) l utilisateur
de l appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage
est susceptible d en compromettre le
fonctionnement.
Starting and operating/BSD/RCTA

Handling of radar sensors

Radar sensors
The radar sensors, one on each side of
the vehicle, are mounted inside the rear
bumper.
CONTINUED
7-65