Transfer Mode Options - Siemens SIMATIC TP 270 Operating Instructions Manual

7.2.3

Transfer mode options

Transfer mode options
The following options can be set for transfer mode:
• The HMI device can be switched to transfer mode automatically when in normal operation
• Select a specific connection type so that transfer can only occur either via a serial
Setting the communication channel
The "Channel" tab in the Transfer Settings menu can be used to activate the required
communication channel and the "Remote Control" checkbox. In addition to the serial
communication channel, a second channel can also be selected to transfer data from the
configuration computer to the HMI device.
Figure 7-1
Press the "Advanced" button to define the following settings:
• For transfer MPI or PROFIBUS-DP, define the "Address" bus parameter and
• Define the driver for transfer via Ethernet.
TP 270, OP 270, MP 270B (WinCC flexible)
Operating Instructions, Edition 03/2004, 6AV6691-1DD01-0AB0
as soon as a transfer is started on the connected configuration computer.
connection, MPI/PROFIBUS-DP, USB or Ethernet connection.
Note
Do not make any other changes when runtime is running or when the HMI device is in
transfer mode.
"Transfer Settings" dialog, "Channel" tab
"Transmission Rate" and "Highest Station" network parameters.
Prepare and backup project
7.2 Transfer
7-5