Configuring Network Access - Siemens SIMATIC TP 270 Operating Instructions Manual

Operating system and configuration
6.3 Network operation
6.3.4

Configuring network access

Requirements
The network is set up on the HMI device.
Procedure
In order to use the network functions in the WinCC flexible configuration software, specify
the relevant UNC assigned names at those points where paths have been entered for files or
directories.
Example 1: Logs
If you want to perform logging on the server in the example above, replace the predefined
archive memory location "\Storage Card\Logs" with the UNC assigned name for the server,
e.g. "\\mrnbg2\data\logs".
Example 2: Recipe data records
In order to store recipe data records in the network, replace the predefined path name
"\Flash\Recipes" with the UNC assigned name for the server, i.e. "\\mrnbg2\data\recipes".
The same applies for exporting and importing recipe data records using the functions
"ExportDataRecords" and "ImportDataRecords". In this case, replace the parameter "File
name" with the UNC assigned name for the server.
See also
Configuring the HMI device for network operation (Page 6-19)
Test network (Page 6-21)
6-22
TP 270, OP 270, MP 270B (WinCC flexible)
Operating Instructions, Edition 03/2004, 6AV6691-1DD01-0AB0