Error Messages - KVH Industries TracPhone V7 User Manual

TracPhone V7 User's Guide
Chapter 4 - Troubleshooting

Error Messages

50
The table below lists error messages that might appear on the control
unit display to indicate a system problem. Many of these faults should
only be repaired by a KVH-certified technician. For details on finding
a KVH-certified technician, see
Error Message
WAITING FOR GPS
ERROR:
GPS FAILURE
OFFLINE
OUTSIDE COVERAGE
TRANSMIT INHIBITED
BY CTRL UNIT
RF RADIATION HAZARD!
TRANSMIT INHIBITED
ERROR:
ANTENNA AZ ASSEMBLY
"Technical Support" on page
Description
The system is not yet receiving
valid position data from the GPS.
It might take a few minutes for
the GPS to acquire a fix. If this
message does not clear, check for
antenna blockage. You can also
try turning the control unit off,
then back on.
The GPS is not communicating
with the control unit. Try turning
the control unit off, then back on.
If the error persists, the GPS
module inside the antenna might
need to be replaced. Contact a
KVH-certified technician.
Your vessel is located outside the
mini-VSAT Broadband coverage
area, where service is unavailable
(or you are located within a
governmentally restricted area).
Service will be restored once you
reenter the coverage area.
The transmitter is temporarily
disabled due to severe sea
conditions or excessive vibration.
The antenna is pointing within
one of your programmed RF
radiation hazard zones. See
"Configuring RF Radiation
Hazard Zones" on page 23
details.
The antenna's azimuth motor or
limit switch failed. Contact a
KVH-certified technician.
69.
for