Backspace; Carriage Return - Oki MICROLINE 591Elite User Manual

Carriage return

Carriage return
When it receives this command, the printer will print data from the print buffer and
return the printing position to the beginning of the line. If Auto Line Feed is ON in the
menu, the printer adds a line feed to each carriage return. This command cancels one-
line double width printing.

Backspace

Backspace
The backspace command prints any data that is in the print buffer and moves the
printhead one character to the left. The actual width of the backspace depends on the
current pitch. If you are using proportional spacing, the BS command moves the
printhead 1/10 inch to the left.
Reset
Reset (initialise printer)
or
or
or
(n1 + n2 x 256) stands for the following parameters byte length.
m1 specifies the initialistaion mode.
m2 specifies the ID number of the printer, 03H, 16H, 23H or 24H (to be specified).
m3 and m4 specify the menu setting, after initialisation.
This command removes any data in the printer's buffer and returns the printer to the
current menu settings. It will override any features set on the printer's front panel. This
is also called initialisation. If Reset Inhibit is YES in the menu, these commands will
be ignored .
Decimal Hex
13 0D
Decimal Hex
8 08
Decimal Hex
27 64 1B 40
28 64 1C 40
27 125 00 1B 7D 00
27 91 75 1B 5B 4B
n1 n2 m1 n1 n2 m1
m2 m3 m4 m2 m3 m4
ASCII Comp
CR E P A
ASCII Comp
BS E P A
ASCII Comp
ESC @ E
FS @ E
ESC } NUL E P A
ESC [ K P A
n1 n2 m1
m2 m3 m4
3 – 37