Oki MICROLINE 591Elite User Manual page 63

If p1 = 0 and p2 = 0, there is no change.
r1 defines the font spacing.
If r1 = 0, no change.
If r1 = 1, fixed pitch defined by p1 and p2 is available.
If r1 = 2, proportional spacing is defined.
Character Spacing
Set character spacing
n = 0 to 127
Use this command to adjust the amount of space to the right of each character. This
value is expressed in dots; the number of dots per inch depends on the current print
mode, as shown in the table below.
Print Quality
LQ
Draft
Proportional
Proportional Condensed
Decimal Hex
27 32 n 1B 20 n
Character Spacing Increments
ASCII Comp
ESC SP n E
CPI DPI
10 180
12 180
15 180
17 180
20 180
10 120
12 120
15 120
17 120
20 120
180
180
3 – 15