Troubleshooting; Led Indicators; Errors - Datamax w1110 User Manual

6

Troubleshooting

LED Indicators

The printer LEDs are also used to indicate errors and warnings. Refer to the following
chart:
Table 1: LED Indicators
Action
Warning
Error
Control Mode
Data Transfer
Configuration
Hardware Failure
Cooling
Maintenance Needed
Label Presented

Errors

The following errors may occur:
Errors
SYSTEM ERROR
OUT OF PAPER
PRINTHEAD HOT
FPGA HARDWARE
NV RAM HARDWARE
PAPER SENSOR BLOCKED
PAPER CALIBRATION
Green LED
Not affected by
Warning
Off
Short Blink with a
Pause
Solid
Off
Slow Blink
Not affected by
Maintenance Needed
Fast Blink
Software or label format error. Communication rate too slow.
Out of paper
Printhead is too hot
Analog to digital converter hardware fault
Non-volatile memory hardware fault
Top-of-form sensor hardware fault or sensor calibration
performed with paper installed
Could not calibrate media
Red LED
Slow Blink
Solid
Not affected Only applies when printer is in
by Control configurator session
Mode
Printer is not operational during this
time
0.1 seconds on and 2.3 seconds off
Solid Short duration
Fast Blink
Slow Blink LEDs blink in sync
Short Blink 0.8 seconds on and 3.2 seconds off
with a Pause
Not affected Waiting for the operator to remove the
by Label label
Presented
Description
59
Notes
Workstation Series User's Guide