Sensor Calibration; Printer Settings - Datamax w1110 User Manual

Sensor Calibration

Sensor calibration is set during the manufacturing process and should only need to be
performed after upgrading the printer's software. This is indicated by the red LED
blinking slowly after power-up.
1. Remove the paper from the printer.
2. Close and latch the printer cover.
3. Press the Reset, Stop/Resume, and the Feed/Cancel buttons together with one
short press.
Note: The green LED will have a fast blink sequence.

Printer Settings

All printer settings can be adjusted in the configuration utility or the printer's internal web
pages. Refer to the Help section in the utility for more information.
19
Connections and Setup | 3
Workstation Series User's Guide