Control Panel; Leds; Led Indicators - Datamax w1110 User Manual

Control Panel

The control panel consists of the two (2) main buttons on the printer cover, two (2) LEDs
on the printer cover and the reset button on the back of the printer. All three are used to
perform certain printer functions.

LEDs

The green and red LEDs may blink during the operation of the printer. There are
functions of the printer where the blinking lights can be used to interpret the printer's
state.
A slow blink is considered a repeating blink that lights for 0.8 seconds and then turns
off for 0.8 seconds. This sequence will repeat until the task has been completed.
A fast blink is considered a repeating blink that lights for 0.1 seconds and then turns
off for 0.1 seconds. This sequence will repeat until the task has been completed.
A double blink is considered two fast blinks with a pause in between.
More information is presented in the troubleshooting section.

LED Indicators

The LEDs are used to indicate the printer's state.
Table 2: LED Chart
Light
Green
Red
Green/Red
Combination
Fast Blink - Waiting for an operator action
Slow Blink - Printer is processing data
Solid Light - Printer ready state
Fast Blink with Pause - Configuration Utility Control Mode
Fast Blink - Hardware Error
Slow Blink - Warning
Solid Light - Fault
Fast Blink with Pause - Maintenance Timer Expired
Fast Alternating Blink - Recovery Mode
Slow Alternating Blink - Upgrade in Progress
Slow Synchronized Blink - Cooling Down
Synchronized Double Blink - Power-up in Progress
Printer State
17
Connections and Setup | 3
Workstation Series User's Guide