Powerware Prestige 6000 Installation And Operator's Manual page 65

To access the front panel communication options, perform the following
steps:
Powerware ® Prestige Series Installation and Operator's Manual for IBM Applications (6000 VA) Uncontrolled Copy
1. If the UPS is powered on, prepare your equipment for
shutdown.
Press and hold the Output

ceases (approximately three seconds).
The indicator remains lit indicating Normal mode, load
offline.
Switch the input breaker on the power processing unit to the
OFF (O) position. Wait until all indicators turn off and then
continue to the next step.
2. Switch the PPU input breaker to the ON (
pressing the Output
indicators begin flashing.
3. Press and hold the Output
alarm beeps again.
A single indicator, corresponding with the current setting,
remains flashing.
4. Press the Output
communication options, top to bottom. Each time you press the
button, the UPS beeps and the next indicator flashes.
NOTE If you do not save a selection within 30 seconds, the setup automatically
aborts and switches back to the original configuration.
5. Press and hold the Output On button until the alarm beeps to
select and save a communication option. Failure to release the
button immediately after the beep will cause the UPS to abort
the setup.
6. Press the Output On button again to return the UPS to
Normal mode.
NOTE Printer mode selections are the only serial communication modes available
from the front panel.
Off button until the long beep
Off button until the alarm beeps. All
Off button a second time until the
Off button to scroll through the
Communication
) position while
|
57