Powerware Prestige 6000 Installation And Operator's Manual page 46

Installation
38 Powerware
6. Plug the input and output power cords of the PPDM into the
input and output power connectors on the PPU rear panel.
Figure 19 on page 52 shows the PPDM and PPU rear panel
connections.
7. The equipment to be protected by the UPS should be powered
off. Plug the equipment into the power output receptacles on
the PPDM rear panel.
NOTES
:
Use the IEC 320-C19/C20 output cord provided with the PPDM to connect the
AS/400 to the PPDM.
:
You may have to use the output cord provided with the PPDM for 230V usage.
:
When using the PPDM, it is recommended that the equipment not be plugged
into the PPU.
:
Do not protect laser printers with the UPS/PPDM because of the exceptionally
high cyclic power requirements of the heating elements.
8. Plug the battery cord into the battery connector on the PPU. All
battery connectors are polarized to prevent incorrect
connection.
9. If additional battery cabinets are to be used, plug the battery
cord of the second cabinet into the battery connector of the first
cabinet after pivoting the battery connector guard out of the
way. Follow this procedure for each additional battery cabinet.
10. Remove the breaker tie from the circuit breaker on all battery
cabinets.
11. If you are using a REPO switch, follow the "REPO Installation"
instructions on page 41.
® Prestige Series Installation and Operator's Manual for IBM Applications (6000 VA) Uncontrolled Copy