Installing A Psr150(Jd362A, Jd362B, Jd366A, Or Jd366B) Power Supply - HP flexnetwork 5510 hi series Installation Manual

Figure 22 Installation procedure
Figure 23 Removal procedure
Turn off the circuit
breaker
Installing a PSR150(JD362A, JD362B, JD366A, or JD366B)
power supply
CAUTION:
To prevent damage to the power supply or the connectors on the backplane, insert the power supply
gently. If you encounter a hard resistance when inserting the power supply, pull out the power supply
and insert it again.
For the PSR150-A/PSR150-A1 (JD362A/JD362B) and PSR150-D/PSR150-D1 (JD366A/JD366B)
power supplies, the installation and removal procedures are the same. The following takes the
PSR150-A1 (JD362B) power supply as an example.
To install a power supply:
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
1.
Remove the filler panel from the target power supply slot as follows:
2.
a. Remove the screws on the filler panel.
b. Use a flathead screwdriver to remove the filler panel.
Figure 24 Removing the filler panel
Unpack the power supply and verify that the power supply model is correct.
3.
Correctly orient the power supply with the power supply slot (use the letters on the power supply
4.
faceplate for orientation), grasp the handle of the power supply with one hand and support its
Disconnect the power
cord
19
Remove the power
supply