Installing The Power Supply - HP ProCurve 4000M Installation Manual

Step 1. Insert the power supply into the opening.
Step 2. Tighten the four retaining screws to hold the power supply in place as
Step 3. Go to Chapter , "Connecting the Power Supply," on page 26 and follow
Figure 4-2
Replacing the DC Power Supply
Replacing the DC Power Supply

Installing the Power Supply

Lower it until it rests on the bottom of the switch chassis.
Slide it in until it connects to the connector at the back of the slot.
The power supply face plate should be flush with the back of the switch.
shown in Figure 4-2, "Installing the Power Supply into the Switch
Chassis."
The screws can be tightened with either a flat-bladed or Torx T-10
screwdriver. Be careful not to overtighten the screws.
the instructions on connecting the power supply to a DC power source.
Installing the Power Supply into the Switch Chassis
34
Retaining Screws
Chapter 4