Removing A Psr150(Jd362A, Jd362B, Jd366A, Or Jd366B) Power Supply; Installing A Psr720-56A/Psr1110-56A (Jg544A/Jg545A) Power Supply - HP flexnetwork 5510 hi series Installation Manual

bottom with the other, and slide the power supply slowly along the guide rails into the slot (see
callout 1 in
Fasten the captive screws on the power supply with a Phillips screwdriver to secure the power
5.
supply in the chassis (see callout 2 in
verify the installation of the power supply.
Install the filler panel over the empty power supply slot to prevent dust and ensure good
6.
ventilation if you install only one power supply.
Figure 25 Installing a PSR150-A1 (JD362B) power supply
Removing a PSR150(JD362A, JD362B, JD366A, or JD366B)
power supply
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
1.
Disconnect the power cord.
2.
Loosen the captive screws of the power supply with a Phillips screwdriver until they are
3.
completely disengaged.
Grasp the handle of the power supply with one hand and pull it out a little, support the bottom
4.
with the other hand, and pull the power supply slowly along the guide rails out of the slot.
Put away the removed power supply in an antistatic bag or the power supply package bag for
future use.
Install the filler panel to prevent dust and ensure good ventilation if no power supply is installed
5.
in the slot.
Installing a PSR720-56A/PSR1110-56A (JG544A/JG545A)
power supply
CAUTION:
To prevent damage to the power supply or the connectors on the backplane, insert the power supply
gently. If you encounter a hard resistance when inserting the power supply, pull out the power supply
and insert it again.
For the PSR720-56A (JG544A) and PSR1110-56A (JG545A) power supplies, the installation and
removal procedures are the same. The following takes the PSR720-56A (JG544A) power supply as
an example.
To install a power supply:
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
1.
Remove the filler panel from the target power supply slot, as shown in
2.
Figure 25).
Figure 25). If the captive screw cannot be tightly fastened,
20
Figure 26.