Restoring The Delivery State - Siemens simatic ET 200SP User Manual

9.3

Restoring the delivery state

Introduction
The entire image of your operating system and your Runtime software are located on the
supplied Restore DVD. You can use the SIMATIC restore menu to restore the original
software of the CPU 1515SP PC.
Alternatively, you can use the Restore menu to create a bootable USB stick in order to
restore the original software without a DVD-ROM drive. Refer to the section Restoring
delivery state using USB stick (Page 78).
Note
Restoring existing system partition
If your projects are stored on partition D: you can use the option "Restore existing system
partition" to restore partition C: with the operating system and the Runtime software, without
your project data being affected.
Note
Using Multitouch panels
The restoration of the original software is not possible with a Multitouch panel, because the
Multitouch driver is not available until after the installation of the operating system.
CPU 1515SP PC
Manual, 12/2014, A5E32701806-AA
Maintenance
9.3 Restoring the delivery state
75