Zanussi ZWF 14380G User Manual page 24

Table of Contents

Advertisement

Water inlet
The inlet hose is supplied with the appliance
and it can been found inside the machine drum.
Warning! This appliance must be
connected to a cold water supply.
Caution! Before connecting up the
appliance to new pipework or to pipework
that has not been used for some time, run off a
reasonable amount of water to flush out any
debris that may have collected.
Caution! Do not use the hose from your
previous appliance to connect to water
supply.
35°
24
If necessary, check
the setting with a spi-
rit level.
1. Connect the ap-
propriate end of
the hose to a tap
with a 3/4"
thread. Always
use the hose
supplied with the
appliance.
45°
2. Connect the other end of the inlet hose to
the back of the appliance. The inlet hose
can ONLY be turned as showed in the
picture.
Do not place the inlet hose down-
wards. Angle the hose to the left or right
depending on the position of your water
tap. Set the hose correctly by loosening
the ring nut. After positioning the inlet
hose, be sure to tighten the ring nut again
to prevent leaks.
Caution! The inlet hose must not be
lengthened. If it is too short and you do not
wish to move the tap, you will have to purchase
a new, longer hose specially designed for this
type of use.
Warning! Installation should comply
with local water authority and
building regulations' requirements.
The appliance must be connected to a
cold water supply.
A minimum water pressure of 0.05 MPa (0.5
bar) is required for safe operation of the
appliance.
If you cannot make the cold water connection
direct from the rising mains, you may be able to
operate the appliance from your cold water
storage system.
There should be a minimum vertical distance of
5.02 m (16.5 ft) between the appliance's inlet
and the bottom of the water storage tank.
Water drainage
This appliance is designed to be permanently
plumbed into your home's drainage system us-
ing one of the following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain hose
using the "U" piece" supplied.
www.zanussi.com

Advertisement

Table of Contents
loading

Table of Contents