Zanussi ZWF 14380G User Manual page 25

"U" piece supplied
Place the drain hose into your standpipe,
which should have an internal diameter of ap-
proximately 38 mm thus ensuring there is an
air break between the drain hose and stand-
pipe.
When discharging into a standpipe ensure
that the top of the standpipe is no more than
90 cm (35.4'') and no less than 60 cm (23.6'')
above floor level.
The drain hose may be extended to a maxi-
mum of 4 metres. An additional drain hose
and joining piece is available from your local
Service Force Centre. The joining piece must
have an internal diameter of 18 mm.
www.zanussi.com
38 mm (1.5")
standpipe
diamater
30 cm (12")
Min. 60 cm (23.6")
Max. 90 cm (35.4")
If your drain hose
looks like this (see
beside) you do not re-
quire the "U" piece".
Just push the hose
firmly in to the stand-
pipe.
2. Onto a sink outlet spigot.
If the outlet spigot
has not been used
before, remove any
blanking plug that
may be in place.
If you intend to drain the hose from the ma-
chine into a sink, make sure that the sink is
empty and the plug hole is not blocked. Use
the plastic "U - Piece" supplied.
Special conditions
If the floor is carpeted or covered with crumbly
or soft material, insert a rigid support base un-
der the feet to prevent noise, vibration or dis-
placement. The base should protrude a few
centimetres beyond the edges of the appliance.
Warning! The appliance should NOT be
placed on deep pile carpeting.
Note!
Please ensure that when the appliance is
installed it is easily accessible for the engineer
in the event of a breakdown.
Loop
Push the drain hose
onto the spigot and
secure with a clip, en-
sure a loop is formed
in the drain hose (see
above) to prevent
waste from the sink
entering the appli-
ance.
25