Daily Use - Zanussi ZWF 14380G User Manual

Daily use

Load the laundry
Measure out the detergent and the fabric
softener
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent re-
quired, pour it into the main wash compart-
ment or in the appropriate compartment if
the selected programme/option it requires
(see more details in "Detergent dispenser
drawer").
If required, pour fabric softener into the com-
partment marked
not exceed the «MAX» mark in the drawer).
Close the drawer gently.
www.zanussi.com
Open the door by
carefully pulling the
door handle out-
wards. Place the
laundry in the drum,
one item at a time,
shaking them out as
much as possible.
Close the door.
Make sure that no
laundry stays be-
tween the seal and
the door. There is a
risk of water leakage
or damage to the
laundry.
(the amount used must
Select the required programme by turning
the programme selector dial (1)
Turn the programme selector dial to the re-
quired programme. The green pilot light of the
button 6 starts to flash.
The selector dial can be turned either clockwise
or counterclockwise. Turn to position «Off» to
reset programme/ switch the machine off.
At the end of the programme the selector
dial must be turned to position «Off» , to
switch the machine off.
Caution! If you turn the programme
selector dial to another programme when
the machine is working, the red pilot light of
button 6 will blink 3 times to indicate a wrong
selection. The machine will not perform the new
selected programme.
Select the spin speed, the Night Cycle or
the Rinse Hold option by pressing button
2
The washing machine will automatically select
the maximum spin value provided for the pro-
gramme you have chosen. (See "Washing pro-
grammes" for the maximum allowed spin
speed).
Press this button repeatedly to change the spin
speed, if you want your laundry to be spun at a
different speed. The relevant light will light up.
Select the available options by means of
buttons 3 and 4
Depending on the programme, different options
can be combined. These must be selected after
choosing the desired programme and before
starting the programme. When these buttons
are pressed, the corresponding pilot lights illu-
minate. When they are pressed again, the pilot
lights go out. If an incorrect option is selected,
the integrated red pilot light of the button 6
flashes 3 times and the message Err is dis-
played.
For the compatibility among the washing pro-
grammes and the options see chapter «Wash-
ing programmes».
9