Zanussi ZWF 14380G User Manual page 26

In the interest of the environment
The appliance should be connected to the
FOUL drainage system, the water will then be
taken to a sewage works for treatment before
being discharged safely into a river.
It is essential that these appliances are not con-
nected to the surface water drainage system as
this water is discharged directly into a river or
stream and may cause pollution.
If you require any further advice please contact
your local water authority.
SHOWER
BATH
WASHING
MACHINE
RAINWATER
'RUN-OFF'
SURFACE WATER
DRAINS & SEWERS
UNTREATED
DISCHARGE
RIVER
Electrical connection
Any electrical work required to install this appli-
ance should be carried out by a qualified electri-
cian or competent person.
Warning! THIS APPLIANCE MUST BE
EARTHED.
The manufacturer declines any liability
should this safety measure not be
observed.
Before switching on, make sure the electricity
supply voltage is the same as that indicated on
the appliance's rating plate.
Warning! Information on the electrical
connection is given on the rating
plate on the inner edge of the appliance
door.
The appliance is supplied with a 13 amp plug
fitted.
26
SINK TOILET
BIDET
DISHWASHER
FOUL DRAIN
FOUL SEWERS
SEWAGE TREATMENT
WORKS
TREATED DISCHARGE
RIVER
In the event of having to change the fuse in the
plug supplied, a 13 amp ASTA approved
(BS1363/A) fuse must be used.
Should the plug need to be replaced for any
reason, proceed as described below.
The wires in the mains lead are coloured in ac-
cordance with the following code:
1
3
4
The wire coloured green and yellow must be
connected to the terminal marked with the letter
«E» or by the earth symbol
and yellow.
The wire coloured blue must be connected to
the terminal «N» or coloured black.
The wire coloured brown must be connected to
the terminal marked «L» or coloured red.
Upon completion there must be no cut, or stray
strands of wire present and the cord clamp
must be secure over the outer sheath.
Warning! A cut off plug inserted into a
13 amp socket is a serious safety
(shock) hazard.
Ensure that the cut off plug is disposed of
safely. Should the appliance power supply
cable need to be replaced, this must be
carried out by our Service Force Centre.
The appliance should not be connected to
the electrical supply by means of an
extension cable.
Note!
When the appliance is installed the power sup-
ply cable must be accessible.
Permanent connection
In the case of permanent connection it is neces-
sary that you install a double pole switch be-
tween the appliance and the electricity supply
(mains), with a minimum gap of 3 mm between
the switch contacts and of a type suitable for
Green & Yellow
1
Brown
2
Cord clamp
3
Blue
4
2
or coloured green
www.zanussi.com