Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi ZWF145W
Summary of Contents for Zanussi ZWF145W
- Page 1 WASHING MACHINE USER MANUAL ZWF145W...
-
Page 2: Table Of Contents
THE CONTENTS SECTION 1:BEFORE USING Safety warnings Recommendations SECTION 2:INSTALLATION Removal of transportation screws Adjustment of feet Electrical connection Water supply connection Water drain connection SECTION 3:TECHNICAL SPECIFICATIONS SECTION 4:CONTROL PANEL Start/Pause button Function indicator lights Function buttons Program knob SECTION 5:WASHING YOUR LAUNDRY Before washing Running the machine... -
Page 3: Section 1:Before Using
SECTION 1:BEFORE USING SAFETY WARNINGS Do not use a multiple socket or extension cord. Do not insert a plug with damaged or broken cord into the socket. If the cord is damaged it should be replaced by the manufacturer or appointed service agent in order to avoid a hazard. -
Page 4: Section 2:Installation
If you will not use your machine for a long time, unplug your machine, close the water supply and leave the door open in order to keep the inside of the machine dry and for prevention from unpleasant odour. As a result of the quality control procedures, a certain amount of water may remain in your machine. -
Page 5: Electrical Connection
You can adjust the balance of your machine from its feet. First, loosen the plastic adjustment nut. Adjust by rotating the feet upwards or downwards. After the balance has been reached, tighten the plastic adjustment nut again by rotating it upwards. Never put cartons, wooden blocks or similar materials under the machine to balance the irregularities on the level of the ground. -
Page 6: Water Drain Connection
Cold water inlet (White filter valve) WATER DRAIN CONNECTION Be sure that water inlet hoses are not folded, twisted, crushed or elongated by stretching. Water drain hose should be mounted at a height of minimum 60 cm, maximum 100 cm from the ground. The end of the water drain hose may directly be fitted to the dirty water outlet hole or a special apparatus mounted on the outlet bracket of the wash-stand. -
Page 7: Section 3:Technical Specifications
SECTION 3:TECHNICAL SPECIFICATIONS ZWF145W Maximum dry laundry capacity (kg) Recommended loading (kg) Height (cm) Width (cm) 59,6 Depth (cm) Maximum spin cycle ( rpm ) (*) Maximum spin cycles depend on the model you’ve chosen 1-Upper tray 5-Handle 2-Detergent drawer... -
Page 8: Section 4:Control Panel
SECTION 4:CONTROL PANEL 1-Detergent drawer 5-Program knob 2-Start/pause light 6-Start/pause button 3-Function indicator lights 7-Function buttons 4-Program ready light 8-Program end light... -
Page 9: Start/Pause Button
START/PAUSE BUTTON Used to start a selected program or pause during running. WARNING! It is required for the program knob to be brought to O(off) position before selecting the program or changing a continuing program. FUNCTION INDICATOR LIGHTS When the start/pause button or any function button is pressed,the corresponding light turns on.The light turns off when the function button or start/pause button is re-pressed, or when the process the selected function is completed. -
Page 10: Program Knob
WARNING! Functions vary depending on the model you have chosen.If you forgot to use additional function and your machine starts to wash push the additional function button if the indicator light is on. Additional function will be activated.If the indicator light is not on,additional function will not be activated. -
Page 11: Section 5:Washing Your Laundry
1-Cotton 90°C 2- Cotton 60°C with prewash 3- Cotton 60°C 4- Cotton 40°C 5- Eco wash 6- Quick wash 7- Cotton cold 8- Synthetic 60°C 9- Synthetic 40°C 10- Synthetic cold 11- Delicate 30°C 12- Wool 30°C 13-Rinsing 14-Spin 15-Draining 0- OFF SECTION 5: WASHING YOUR LAUNDRY Plug the machine. -
Page 12: Placement Of Clothes Into Machine
Pull the textiles like trousers,knitted fabric,t-shirt and sweat shirt inside out. Wash your small clothes like socks and handkerchiefs in a washing bag. Wash up tol 90 ˚C Wash up to 60 ˚C Wash up to 30 ˚C Not washable in washing machine Placement of the clothes into the machine Open the door of your machine. -
Page 13: Running The Machine
You can use fluid detergents in all programs without pre-washing. For this, mount the fluid detergent level plate in the second compartment of the detergent drawer and arrange the amount of fluid detergent according to the levels on this plate. fluid detergent level plate... -
Page 14: Section 6:Maintenance And Cleaning
The door will be unlocked in approximately two minutes after the program ends.You can open the door by pulling the handle of the door towards yourself and take out your clothes. After you unload your clothes leave the door open to dry the interior of your machine. - Page 15 MAX DRY LOAD DETERGENT ADDITIONAL FUNCTION CAPACITY (kg) PROGRAM TYPE OF LAUNDRY EXPLANATIONS COMPART. BUTTON ZWF145W Dirty, boil, cotton and linen 1-COTTON 90˚ textile 2-COTTON 60˚ Very dirty, cotton, coloured and linen textile (PREWASH) Dirty, cotton, coloured and Underwears, sheet, 3-COTTON 60˚...
- Page 16 EXPLANATIONS COMPART. BUTTON ZWF145W 13-RINSING When you need an additional rinsing to be done to your clothes after the washing process, you can use this program for all kinds of clothes. When you need an additional spinning to be done to your clothes after the washing process, you can use this program for all kinds of 14-SPINNING clothes.
-
Page 17: Pump Filter
Remove the water inlet hose. Remove the filters found on the water inlet valves by using a pincer and wash thoroughly with a brush. Clean the filters of the water inlet hoses located on the tap side by removing manually together with the seal. After you clean the filters, you can fit them the same way as you have removed. -
Page 18: Detergent Drawer
WARNING! Danger of being scalded! Since the water inside the pump maybe hot, wait for it to cool. DETERGENT DRAWER Detergents may form a sediment in your detergent drawer or in housing of the detergent drawer in time. To clean the sediment, pull out the detergent drawer from time to time.To pull out the detergentdrawer: Pull the detergent drawer to the end.(DIAGRAM-1) Lift the front of the drawer, continue to pull until the drawer is pull... -
Page 19: Siphon Plug
SIPHON PLUG Pull out the detrgent drawer. Remove the siphon plug and clean the residues of the softener thoroughly. Fit the cleaned siphon plug in its location. Check if it placed properly. THE CABINET Clean the exterior surface of the cabinet of your machine with lukewarm water and a cleaning substance that will not irritate the cabinet. -
Page 20: Section 7:Practical Information
SECTION 7:PRACTICAL INFORMATION Alcoholic beverages: The stain point, should first be washed with cold water, than should be wiped with glycerine and water and be rinsed with water mixed with vinegar. Shoe Polish: The stain should be slightly scratched without ruining the cloth, rubbed with detergent and rinsed. -
Page 21: Section 8:Avoiding Minor Faults
Mould: Mould stains should be cleaned as soon as possible. The stain should be washed with detergent, and if it does not disappear, it should be wiped with oxygenated water (in proportion of 3%). Ink: Hold the stained area under cold water and wait until the inky water completely runs off. - Page 22 METHODS OF FAILURE PROBABLE CAUSE ELIMINATION Insert the plug into the It is unplugged. socket. Your fuse is defected. Change your fuse. The electric power is Check the electric off. power. Start/pause button has Press the start/pause Your machine does not not been pressed.
- Page 23 METHODS OF FAILURE PROBABLE CAUSE ELIMINATION There is a small It does not prevent amount of clothes in operation of the the device. machine. Do not exceed the Excessive amount of recommended quantity clothes are filled in the Your machine is of clothes and spread machine or the clothes vibrating.
- Page 24 METHODS OF FAILURE PROBABLE CAUSE ELIMINATION Clothes exceeding the Put the clothes in your maximum capacity machine in a manner has been filled in your not to exceed its machine. maximum capacity. Use the amount of The washing result is Your water may be detergent according to not good.
-
Page 25: Section 9:Automatic Failure Detection System
METHODS OF FAILURE PROBABLE CAUSE ELIMINATION The unbalanced load control system will try to distribute your clothes in a homogenous manner. No failure. The The spining process is After your clothes are unbalanced load not done or starts with distributed, passage to control may works in delay . - Page 26 FAILURE FAILURE PROBABLE THE PROCESS CODE INDICATOR FAILURE TO BE DONE Turn on the tap to the end.Water may be cut, check it.If the problem is still The water level continuing,your in your machine machine will is below heater. The program automatically Err 02 The pressure of...
- Page 27 FAILURE FAILURE PROBABLE THE PROCESS CODE INDICATOR FAILURE TO BE DONE Shut down your The heater of your machine and The start/pause machine or the unplug. Turn off Err 05 light and program heat sensor has your tap and apply end light blink.
-
Page 28: Section 10:International Washing Signs
SECTION 10: INTERNATIONAL WASHING SIGNS Washing Do not wash Lukewarm iron. Medium hot iron. temparature. (hand wash) Do not tumble Hot iron. Do not iron. Hang to dry. dry. Drip dry. Dry flat. Do not bleach. Handy to bleach. All of these are dry cleaning symbols. The letters are to instruct the cleaner what type of solvent to be used.