Zanussi ZWF 14380G User Manual page 10

Select the Delay Start by pressing button
7
Before you start the programme, if you wish to
delay the start, press this button to select the
desired delay.
The selected delay time value will appear on the
display for a few seconds, then the duration of
the programme will appear again.
You must select this option after you have set
the programme and before you start the pro-
gramme.
You can cancel or modify the delay time at any
moment, before you press button 6.
Selecting the Delay Start:
1. Select the programme and the required op-
tions.
2. Select the delay start by pressing button 7.
3. Press button 6:
- the machine starts its hourly countdown.
- the programme will start after the selected
delay has expired.
Cancelling the Delay Start after having started
the programme:
1. Set the washing machine to PAUSE by
pressing button 6.
2. Press button 7 once until symbol
pears on the display.
3. Press button 6 again to start the pro-
gramme.
Important!
• The selected delay can be changed only after
selecting the washing programme again.
• The door will be locked throughout the delay
time. If you need to open the door, you must
first set the washing machine to PAUSE by
pressing button 6 and wait a few minutes be-
fore opening the door. After you have closed
the door, press the same button again.
Important! The Delay Start cannot be
selected with DRAIN programme.
Start the programme by pressing button 6
To start the selected programme, press this
button; the corresponding green pilot light
stops blinking.
10
The pilot light Wash (8.1) and Door (8.2 ) illumi-
nate to indicate that the appliance starts operat-
ing and the door is locked.
If you have chosen a delayed start, the machine
will begin the countdown.
Important! If an incorrect option is selected,
the message Err is displayed for a few seconds
and the red pilot light of this button blinks 3
times.
Altering an option or a running
programme
It is possible to change some options before the
programme carries them out.
Before you make any change, you must PAUSE
the appliance by pressing the button 6 .
Changing a running programme is possible only
by resetting it. Turn the programme selector dial
to Off and then to the new programme position.
Start the new programme by pressing the but-
ton 6 again. The washing water in the tub will
be not emptied out.
Interrupting a programme
Press the button 6 to interrupt a programme
which is running, the corresponding green pilot
light starts blinking.
'ap-
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to Off position to cancel a
programme which is running. Now you can se-
lect a new programme.
Opening the door
After the programme has started the door is
locked. If, for any reason, you need to open it,
set firstly the machine to PAUSE by pressing
the button 6. After a few minutes the pilot light
8.2 goes off and the door can be opened.
If the door remains locked, this means that the
machine is already heating or that the water lev-
el is too high. In any case, do not try to force the
door open!
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to Off position. After a
few minutes the door can be opened (pay at-
www.zanussi.com