Genie Z-45/25 Service And Repair Manual page 70

Service and Repair Manual
Engines
Ford models:
1 Disconnect the battery cables from the
battery.
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
2 Disconnect the electrical connectors at the
electrical proportional controller, located on
the drive pump.
3 Support the drive pump assembly with an
overhead crane or other suitable lifting device.
Do not apply any lifting pressure.
4 Remove the drive pump retaining fasteners.
5 Carefully pull the drive pump out until the
pump coupler separates from the flex plate.
Component damage hazard.
Hoses can be damaged if they
are kinked or pinched.
6 Disconnect the electrical connector from the
oxygen sensor at the tailpipe. Do not remove
the oxygen sensor.
7 Support the muffler and bracket assembly with
a suitable lifting device.
8 Remove the exhaust pipe fasteners at the
muffler.
9 Remove the muffler bracket mounting
fasteners from the bell housing. Carefully
remove the muffler and bracket assembly from
the engine.
56
10 Support the engine with an overhead crane or
other suitable lifting device. Do not lift it.
11 Remove the engine mounting plate to bell
housing fasteners.
12 Raise the engine slightly using the overhead
crane and place a block of wood under the oil
pan for support.
13 Remove all of the engine bell housing
retaining fasteners.
14 Carefully remove the bell housing from the
engine.
15 Remove the flex plate mounting fasteners.
Remove the flex plate from the flywheel.
Z-45/25 • Z-45/25J
September 2016
Part No. 1268548