Table of Contents
Advertisement
CFM Loopback Settings
This window is used to configure the CFM Loopback settings on the Switch.
To view this window, click L2 Features > CFM > CFM Loopback Settings as shown below:
The following parameters can be configured:
Parameter
Description
MEP
Name
The name of the Maintenance End Point.
(Max:32
characters)
MEP ID (1-8191)
The ID for the Maintenance End Point between 1 and 8191.
MD
(Max:22
The Maintenance Domain Name.
characters)
MA
(Max:22
The Maintenance Association Name.
characters)
MAC Address
The destination MAC address.
LBMs Number (1-
The number of LBMs to be sent the default value is 4.
65535)
LBM
Payload
The payload length of the LBM to be sent, the default value is O.
Length (0-1500)
LBM
Payload
The arbitary amount of data to be included in a Data TLV, along with the indication of whether
Pattern
the Data TLV is to be included.
(Max:1500
characters)
LBMs Priority
The 802.1p priority to be set in the transmitted LBMs. If not specified it uses the same priority as
CCMs and LTMs sent by the MEP.
Click Apply to implement changes made.
CFM Linktrace Settings
This window is used to configure the CFM linktrace settings on the Switch.
To view this window, click Switch Configuration > CFM > CFM Linktrace Settings as shown below:
DAS-3626 VDSL2 Switch User Manual
Figure 54. CFM Loopback menu
51
Hide quick links:
Advertisement
Table of Contents
