Disarming After An Alarm - Honeywell DOMONIAL User Manual

DISARMING
To disarm the Total and/or the Partial Set, press the disarm button
The associated light blinks during the communication with the panel and then lights
for 3 seconds to confirm the instruction.
The disarming tone is emitted by the panel siren.
Disarming also stops the siren but does not interrupt the transmission to the alarm company.

DISARMING AFTER AN ALARM

If there is an alarm in your absence:
When you press the disarm button
The system will not disarm, in order to avoid beeps that could attract the attention of
an intruder.
To confirm disarming, press the disarm button again.
The associated light blinks rapidly during communication with the panel, then lights
for 3 seconds to confirm disarming.
REMOTE CONTROL OF APPLIANCES
This function requires an optional X10 extension with X10 receivers. Depending on your needs, your
installer will advise you on the different options for controlling appliances.
If this has been configured by the installer, you can control up to 4 household appliances,
however, the default is 2.
The Control button controls the first appliance (receiver 1).
►
The 3 lights blink until the request has been accepted by the system, and then
remain lit for 3 seconds.
The Control and Partial Arm buttons control the next appliance (receiver 2).
►
Lights 1 and 2 blink until the request has been accepted by the system and
then remain lit for 3 seconds.
all three lights blink slowly.
29