Honeywell DOMONIAL User Manual page 11

ARMING THE SYSTEM USING YOUR CODE OR TAG
Before arming the Total Set, ensure that the keypad is in its base.
Press (Total Set arming) or
Enter your user code (programmed during installation. Refer to The Users Menu,
p.15) or present your TAG to the TAG reader of the TCU.
If the system diagnoses a fault on arming, a message is displayed. Press
the arming key again to bypass the faults and continue the arming process.
The start of the arming process is signalled by a series of keypad beeps (and by the
siren, if set up).
The screen counts down the exit time remaining and the Total or Partial set arming
light comes on to confirm arming.
ARMING
--------
PRESENT TAG OR
ENTER CODE
To complete Total Set arming, close the final door. Partial Set arming is completed
at the end of the arming delay.
At the end of the arming delay,
is armed. The arming light then goes out and the screen clears after a few seconds.
Note: Depending on the configuration of your keypad, you may be able to arm your system without the
identification process.
ARMING OF THE ANNEX SET
This can only be done from the TCU menu.
Press
1 - ANNEX
2 - EVENTS
3 - TOOLS
4 - USERS
5 - TESTS
6 - PREFERENCES
Select ANNEX SET from the menu, using
Confirm your choice with
Enter your user code or present your TAG.
The arming process is signalled by a series of beeps and the screen counts down
the exit time remaining.
(Partial Set arming)
or is displayed to confirm that the system
11
or press