How To Use The Wireless Keypad With Prox Reader - Honeywell DOMONIAL User Manual

4

How to use the wireless keypad with prox reader

This keypad is used to arm and disarm your security system using
a valid access code or key TAG.
It is equipped with a proximity reader, positioned in the TAG
Identification Area.
ARMING USING YOUR CODE OR TAG
Press an arming key on the keypad and enter the code or present a programmed TAG.
4- or 6-Digit code
4- or 6-Digit code
4- or 6-Digit code
A flashing red light on the keypad confirms that the code is valid.
The arming tone
exit delay beeps.
Total set arming is completed after you close the final exit door. After the door is
closed, the exit delay beeps stop and the 'arming complete' tone is emitted by the
panel siren.
Partial set or annex set arming is completed automatically at the end of the delay.
(Depending on your system configuration)
Notes:
Always make sure that your arming request is followed by the arming tone.
Always disarm the system when re-entering the premises.
NB: On some keypad models, presenting the TAG for more than 2 seconds will arm the system
without pressing the Arm key.
Arms the total set
Arms the partial set
Arms the annex set
is emitted by the panel siren followed by the
22