5- How To Use The Wireless Keypad With Prox Reader - Honeywell Domonial User Manual

OTHER FUNCTIONS
E
You can deactivate the beeps played on the panel's built-in siren by selecting the
N
SILENT MODE.
You can also activate the chime, which may be associated to some of the
G
detectors in your installation by access ing the CHIME m e n u .
L Home automation functions are in a dedicated menu REMOTE PLUGS. Select the
electrical device** and turn it on or off. On some systems, it is possible to trigger
I
the camera on detectors equipped with one.
S
BATTERY REPLACING
H
The battery indicator on the keypad display indicates when to replace the
battery. Open the battery cover on the back of the keypad and insert a
CR123A 3V battery, respecting the polarities.
** This function requires an optional X10 extension with X10 modules.
WARNING
There is a risk of
explosion in case of
wrong replacement
of the battery.
Replace only with
a battery of the same
type or an equivalent
type, which has been
recommended by the
manufacturer
- 8 -

5- How to use the wireless keypad with prox reader*

The keypad is used to arm and disarm your security system using a valid access
code or key TAG. To use all his functions you must have the master code chosen
during the installation or have the master key TAG.
ARMING USING YOUR CODE OR TAG
• Press an arming key on the keypad
• Enter a valid code or present a programmed TAG**.
- A flashing red light on the keypad confirms that the code is valid.
- The arming tone is emitted by the panel siren followed by the exit delay
beeps. If the system diagnoses a fault on arming, the arming tone is
followed by a tone indicating a fault.
- Arming is automatically completed at the end of the delay (Depends
on site configuration).
Always make sure that your arming request is followed by the arming tone.
If a perimeter fault is signalled on arming, please disarm the system before
verifying doors and windows equipped with contacts.
DISARMING USING YOUR CODE OR TAG
To enable you to get to the keypad without triggering an alarm, your installer has
programmed an entry delay of 30 seconds (Depends on site configuration).
• Enter a valid code or present a programmed TAG
- A green light on the keypad confirms that the code is valid
- The disarming tone is emitted by the panel siren.
Disarming the system will also stop the sirens if an alarm is triggered. Stopping the
siren does not interrupt the transmission of the alarm to the ARC.
Note: Depending on your keypad's configuration, this will disarm the total set or
the entire system. In the latter case, the annex set might need to be re-armed.
* The system may include 0 to 4 keypads of this type.
** On some keypad models, presenting the TAG more than 2 seconds will arm the system without pressing
the Arm key
Total set arming
Part set arming
4 or 6-digit code
4 or 6-digit code
- 9 -
E
N
G
L
I
S
H
TAG
TAG