SW MODE screen
Item
USER1
USER
USER
This is used to set which function is to be assigned to the USER1 button.
INPUT SEL:
Input signal setting (Page 90)
SYS FORMAT:
The system format is selected. (Page 90)
REC FMT/SD:
The recording format for SD is selected. (Page 90)
REC FMT/HD:
The recording format for HD is selected. (Page 90)
SHOT MARK:
A shot mark is recorded on the clip. (Page 54)
TEXT MEMO:
A text memo is recorded. (Page 60)
LCD BL:
LCD backlight setting (Page 103)
OSD OUTSEL:
The OSD/GUI/WFM output destination is set. (Page 103)
AUDIO OUT:
AUDIO OUT selection. (Page 98)
SLOT SEL:
The P2 card slot for recording is switched. (Page 64)
LCD RVS:
LCD reverse setting (Page 104)
WFM:
Waveform monitor (Page 64)
ONE CLIP:
Single clip playback is performed. (Page 58)
This is used to set which function is assigned to "EXIT/2".
The following function can be assigned in addition to the USER1 items.
EXIT:
EXIT function is activated.
This is used to set which function is assigned to "ALT/3".
The following function can be assigned in addition to the USER1 items.
ALT:
ALT function is activated.
Description of settings
The underlined settings are the factory mode settings.