Panasonic P2HD AG-HPG20 Operating Instructions Manual page 111

Recording
Recording does not start.
The P card has been
inserted properly, but
recording is not possible.
The clip created during one
recording has been divided.
• Is the unit's power on?
• Has the battery reached the end of its service life? The battery may
have reached the end of its service life. Although the service life will
differ depending on how the battery has been used, if the battery
can be used only for short periods of time even after it has been
fully charged, it means that it has reached the end of its service life.
• Is the P2 card's write-protect switch at the PROTECT position?
Images cannot be recorded while this switch is at the PROTECT
position.
• Does the P2 card have very little remaining memory? Either save
the data concerned on another media and delete the unnecessary
data on the P2 card concerned or replace the P2 card with a new
card.
• Has the P2 card been formatted properly? Does the card have a
format which cannot be used? Format the card using the unit.
• P2 cards with a memory size of 2 GB cannot be used.
• A clip may be recorded in the divided state when the input signal is
distorted during recording.
P 22
—
P 29
P 55
P 29
P 31
—
111